Dry Contacts Electrical

Or if the contact is mounted as part of an electrical unit that has a power source then the dry contact has no pre wired electrical connection to that power source.

Dry contacts electrical. It could be stand alone such as a pressure switch mounted on a boiler. A common example would be the contacts in a compressor contactor. The contacts simply provide an open or closed state to another device. Dry contacts are not directly provided with power from the switch and are used in switching devices which provide isolation and give a wide variety of output voltage options.

The contactor has a 24v coil in residential but the power supply through the contacts doesn t have any connection to the coil. A wet contact output on a device like a r. A dry contact output on a device like a relay means that the contacts have no voltage or potential difference across the two contacts. Usually some other contacts or devices have the job of starting or stopping the primary.

A dry contact is the synonym of volt free it is not wetted by a voltage source dry contact can refer to a secondary set of contacts of a relay circuit which does not make or break the primary current being controlled by the relay. Basically dry contacts is a switch that has no shared power source or supply integral to the control.